The Selected Boot Device Failed. Press Enter to Continue (SOLUTION)

If you trying to install a new operating system on you HP laptop or just want to boot from another drive. Are keep getting the “The selected boot device failed. Press <Enter> to continue” message, just follow the instructions below to make the laptop boot from any boot-able drive attached to it.

The major reason why this might be happening is because  Secure Boot on the laptop was enabled. Turning off Secure Boot and enabling the Legacy Boot option will fix the problem for you thus allowing you boot the laptop from any boot-able drive of your choice that has been attached to the laptop. So for you to be able to do this, simply follow the guide below;

  • Power on the laptop and while its starting up, continuously tap on F10 on the keyboard. Doing the above will take you to the laptop’s Bios screen.
  • Navigate to Configuration >>> Boot Options and scroll down the page to Secure Boot and then hit enter on your keyboard to change it from Enable to Disable.
  • Locate and move to Legacy Boot. Hit enter on your keyboard to change it from Disable to Enable.
  • Press the F10 key again to apply your changes.

Now you can restart the laptop and change the boot options as needed using the F9 key.

If you do not know how to make your laptop boot from an attached drive or a specific drive, just go to How to change Boot Devices on a Computer and learn how to.

 

Leave a Reply

Your email address will not be published. Required fields are marked *